The ParkBEC 6V is the 6 volt output version of our ParkBEC, the smallest and
lightest switch-mode BEC on the market. It weighs only 6.5g (4.4g without wires)
and is designed for running parkflyer type aircraft with pack voltages up to
33.6V. It can support as many as six sub-micro servos. The 6 volt output option
will give you more servo speed and torque than the 5v version, at the cost of
somewhat increased power consumption.
It uses a switching type power supply to efficiently convert high pack voltages
into a steady 6 volts. If you are using small servos, please make sure that
they can be run from 6v. Some sub-micros, notably the Hitec HS-50, can be damaged
by a 6v supply.
It is especially well suited for small helicopters and 3d planes, where extra
response speed or torque are needed.
The ParkBEC installs between your ESC and receiver. You don't have to modify
your speed control to disable its internal BEC, just plug the ESC into the ParkBEC
6V. The ParkBEC 6V is designed for use with lithium aware ESCs. If your ESC
does not have a setting for high voltage lithium packs, please use the Dimension
which includes an integrated lithium cutoff to protect your flight pack.
For best results, ensure that the ParkBEC 6V is installed at least 2 inches
away from your receiver.
||6V to 33.6v (2s-8s lithium, up
to 21 NiMHs)
||1.25A continuous, 1.5A 60 second
(6 4-9g servos, 4 17g or larger servos)
Can be put in parallel
||Universal (fits all receivers)
- Small 3D aircraft
- Micro helicopters